4.4 防火墙二三层部署综合
1.防火墙三层部署(防火墙使用USG6000V-enspv1.2版本) 1)R1配置 interface GigabitEthernet4/0/0 ip address 12.1.1.1 255.255.255.0 interface GigabitEthernet0/0/1 ip address 192.168.1.2...
第27章 BSR配置
图27-1 BSR配置配置网络拓扑 R1、R2、R3、R4配置Loopback地址,配置0SPF,Loopback地址与直连接口宣告到OSPF网络。 1.R1配置PIM-SM [R1]interface GigabitEthernet 0/0/0 [R1-GigabitEthernet0/...
8.3配置Postfix电子邮件服务
1.安装Postfix。 [root@dsrw ~]# dnf install postfix Updating Subscription Management repositories. Unable to read consumer identity This system is not registered to Red Hat Subscrip...
8.4 hybrid接口2
1.Trunk接口类型不能直接设置为hybrid接口类型,只能先设置为access接口类型,再设置为hybrid接口类型。hybrid主要为满足一定特殊应用需求,完成对同一网段设备之间二层访问。 2.access端口只连...
第15章 GRE隧道
图15-1 GRP隧道配置网络拓扑 1.配置R1、R2、R3间OSPF路由 [R1]ospf 1 [R1-ospf-1-area-0.0.0.0]network 12.1.1.0 0.255.255.255 [R2-ospf-1]area 0 [R2-ospf-1-area-0.0.0.0]network 12.1.1.0 0...
5.2 Windows挂载共享
1.Samba服务器和Windows客户端使用的操作系统以及IP地址 Samba服务器:192.168.10.2 Linux客户机:192.168.10.7 Win7客户机:192.168.10.8 地址栏输入\\192.168.10.2 图4-2 客户机登录smb服务器
3.5 RIPv1与 RIPv2兼容配置
图3-5 RIPv1与 RIPv2兼容配置网络拓扑 1.R3配置RIPv1 [R3]rip 1 [R3-rip-1]version 1 2.查看R2配置RIP路由,无R3路由 [R2]display ip routing-table protocol rip Destination/Mask Proto Pre C...
6.2.2配置反向解析
1.编辑区域配置文件(反向解析区域) [root@dsrw ~]# vim /etc/named.rfc1912.zones zone '10.168.192.in-addr.arpa' IN { type master; file '192.168.10.arpa'; allow-update { none; }; }; 2...








