1.基本概念 同一个网络中存在不同路由协议，在不同协议边界路由器上引入另一种路由协议，称为理由引入或路由重分发。

图16-4 WFQ队列配置网络拓扑 1.FW1配置ACL [FW1]acl number 2001 [FW1-acl-basic-2001]rule permit source 192.168.1.1 0 [FW1]acl number 2002 [FW1-acl-basic-2002]rule permit source 192.16...

图3-4 RIP抑制接口配置网络拓扑 1.R2上抑制连接R1的接口，稍后观察R1、R2的RIP路由表 [R2]rip 1 [R2-rip-1]silent-interface GigabitEthernet 0/0/0 <R1>display ip routing-table protocol ...

图3-3 RIP明文及MD5认证配置网络拓扑 1.R1、R2之间做明文认证 [R1]interface GigabitEthernet 0/0/0 [R1-GigabitEthernet0/0/0]rip authentication-mode simple dsrw.com [R2]interface Gigabit...

图3-5 BGP自动汇总网络拓扑 1.R1配置OSPF [R1]ospf 1 router-id 1.1.1.1 [R1-ospf-1]area 0 [R1-ospf-1-area-0.0.0.0]network 1.1.1.1 0.0.0.0 [R1-ospf-1-area-0.0.0.0]network 12.1.1.0 0.255...

1.查看R1的OSPF路由信息 [R1]display ip routing-table protocol ospf Destination/Mask Proto Pre Cost Flags NextHop Interface 0.0.0.0/0 O_ASE 50 1 D 12.1.1.2 GigabitEthernet0/0/0 2.2.2...

图10-1 OSPVv3配置网络拓扑 10.1 OSPFv3 1.R1配置OSPFv3 [R1]ospfv3 1 [R1-ospfv3-1]router-id 1.1.1.1 [R1]interface LoopBack 0 [R1-LoopBack0]ospfv3 1 area 2 [R1]interface GigabitEtherne...

图37-1 Inter AS MPLS VPN  Option B配置网络拓扑 1.CE1配置BGP [CE1]bgp 100 [CE1-bgp]peer 12.1.1.2 as-number 234 [CE1-bgp]network 1.1.1.1 32 2.PE1配置OSPF [PE1]ospf 1 router-id 2.2.2...

图9-1 VLAN间路由配置网络拓扑 1.SW1配置VLAN [SW1]vlan batch 10 30 [SW1]interface GigabitEthernet 0/0/1 [SW1-GigabitEthernet0/0/1]port link-type access [SW1-GigabitEthernet0/0/1]port...

图2-1 IPV6配置网络拓扑 1.R1配置 [R1]ipv6 [R1]interface GigabitEthernet 0/0/0 [R1-GigabitEthernet0/0/0]ipv6 enable [R1-GigabitEthernet0/0/0]ipv6 address 2012::1 64 [R1]interface Loo...